PIC Programmer
Leading Supplier and Trader of PIC Programmer such as PIC KIT2 Programmer and PICkit 3 Programmer from Mumbai.
PIC Programmer
PIC KIT2 Programmer
The pickit 2 is a low-cost in-circuit debugger (ICD) and in-circuit serial programmer(ICSP). Pickit 2 is intended to be used as an evaluation, debugging and programming aidIn a laboratory environment.
The Pickit 2 offers these features:
- Real-time
- single-step code execution
Breakpoints, Register and Variable Watch/Modify
- In-circuit debugging
- Target Vdd monitor
- Diagnostic LEDs
- MPLAB IDE user interface
- USB interface to a host PC / USB POWERED
- 40 Pin Target Board With FRC Cbale
- ICSP FRC connecter Easy to interface to all our NSK boards
The Pickit 2 allows you to:
- Debug your source code in your own application
- Debug your hardware in real-time
- Program a supported device using Microchip’s ICSP protocol through FRC cable supplied with this kit
Package Content
- Pickit2 Programmer
- Programming Adapter Board
- USB Port Cable
- Software CD ( ,Data sheets,Example Porograms,Manual , MPLAB IDE)
PICkit 3 Programmer
Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer.
In-circuit debugging offers these benefits:
- Low cost
- Minimum of additional hardware needed for debug
- Expensive sockets or adapters are not required
The MPLAB PICkit 3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming™.
PICkit 3 Features
- USB (Full speed 12 Mbits/s interface to host PC)
- Real-time execution
- MPLAB IDE compatible (free copy included)
- Built-in over-voltage/short circuit monitor
- Firmware upgradeable from PC/web download
- Totally enclosed
- Supports low voltage to 2.0 volts (2.0v to 6.0v range)
- Diagnostic LEDs (power, busy, error)
- Read/write program and data memory of microcontroller
- Erase of program memory space with verification
- Freeze-peripherals at breakpoint
- Program up to 512K byte flash with the Programmer-to-Go